Have you ever heard of a car jump starter with rope belongs? If the car does not start, then in winter, often an empty battery in the background. If the battery can no longer be sufficiently charged because it is already overdone, then after a long and cold night, the charging status is no longer enough to start the vehicle. Even if the vehicle lights are switched on accidentally on older vehicles and no light detector is present, the battery can discharge. In any case, jump-start the car is required so that even without the power, the vehicle can be started. Most motorists also have a jumper cable in the car, which can ensure the bridging. With the help of another vehicle battery, the own battery can be supplied with the necessary power for starting.
But that is not necessary. Not infrequently, there is no car to bypass in the environment, or another car driver may also not be willing to provide their battery for bridging. Only a few drivers know that they can help themselves in such a case. The jump start with a rope can be a solution with which a driver can help himself and bring his car to drive without any further jump-start help, other people.
When the car battery strikes
An empty car battery is always a problem. Such a battery, which currently has no power supply, ensures that the entire car is not usable. The car battery provides the starter with the required power, through which the vehicle can then be started. An empty car battery or a battery that has insufficient power for various reasons is suddenly a problem. If no starter cable is available, then many drivers are at a loss. To call the breakdown service means a time expenditure because waiting periods arise practically always if one calls these Dientleister. Nevertheless, a motorist is not entirely helpless or rely on laborious pushing friendly third parties when the empty car battery ensures that the vehicle stops.
This is needed for the jump start.
To start your car, even though the battery is dead, there is less need for resources. The starter without starter cable can be easily replaced if a jack and a rope are present. A stud is already part of the onboard equipment of any vehicle, and a rope is an acquisition that costs only a few euros. Thus, it is worthwhile to carry the rope as emergency aid for the jump start without starter cable always in the car.
Instructions for the jump start with rope.
It is essential to know that the starter aid without starter cable but with rope is only feasible if the car has a manual transmission. Here the start aid with the rope behaves just as if helpers would push the car by hand. Also, the pushing of a vehicle is only possible if the car has a manual transmission. A car with an automatic transmission cannot be pushed. This also applies to the jump start with rope, which can only be implemented with this type of vehicle. It is also important in connection with the rope jump aid that only a raised car can be started with this rope. Therefore, the jack is required to implement such a jump-start alone and without the help of other people.
Step 1: Car must be raised
To implement the car jump starter with rope, you should first lift the car with the jack. Momentous then is a hedge. Under no circumstances should the vehicle slip off the jack, as this will put the car owner, who would like to start the car with the rope, at risk of injury, and there is also a risk that the vehicle will otherwise cause damage to property if it does so was started and then unintentionally gets rolling. Now the rope is in demand and a little force, which the vehicle owner has to apply for starting with the rope.
Step 2: Attach the rope to the tire
The starting of the vehicle is now actually on the same principle as if helpers push the car. To start jump rope, the vehicle owner wraps the rope around one of the driving wheels. The wheel should be wrapped twice with the rope so that the rope does not slip off. Now the first gear is engaged in the manual transmission as if the driver wanted to drive off the car or be pushed by helpers. To do this, the ignition key in the ignition lock must also be turned to level two, i.e., the standard that lies just before starting with the ignition key. Do not forget to make sure to apply the handbrake.
Step 3: Pull the rope strongly.
Now it is time to pull hard on the line. This will get the driving wheel going and start the engine. However, this requires a lot of power that you should have to start the vehicle with the rope. In the worst case, it may even be that the pulling must take place several times until the car or the engine now starts using the mechanical action of the drive wheel. When the vehicle has been launched with the rope, the driving wheels rotate. Before lowering the car so the gear shift should be put back into neutral, otherwise, the vehicle rolls off independently, when the jack is lowered! Here, too, attention should be paid to security.
If the jack is removed, the vehicle can now be used again, and a long drive can charge the battery.
The technique of starting in the second
If starter cables are lacking, the start-up technique in seconds is the perfect way to start the vehicle. Since the goal is to drive the car to a certain speed, you will need to place it on descent or to enlist the help of several people who will push it. First, start by pressing the clutch and engage the second. Then put the contact in contact, taking care not to start. Lower the parking brake while keeping the grip pressed. This will allow the car to ride, taking advantage of the slope, or pushing force of the people helping you. Once the vehicle is moving at about 10 km / h, the speed required for the transmission to engage, all you have to do is take your foot off the clutch. The vehicle should typically start.
Charge the battery with the cigarette lighter
Apart from the second start method, it is possible, by using a starter or “booster battery,” to recharge the battery so that it can start the vehicle. Thanks to this accessory, it is useless to use the starter cables. The principle remains the same as for the cigarette lighter jumper cable, which is used to recharge a discharged battery by connecting the smoke lighter of the broken down vehicle with that of a car that is running. The advantage of the starter-charger is that you will not need another car or open the hood to restore the battery power required to start the car. The charger plugs into the cigarette lighter and requires between 10 to 20 minutes to allow the battery to store the energy needed to start the vehicle.
Check your battery
Could you restart? Congratulations. But it would be safer to check your battery. If it is damaged, do not hesitate to buy a new battery
Leave a Reply